Throughout a heavy rainfall water comes off of the second story roofing and is dumped onto the initial tale roofing. The trouble is where the first story roof meets the 2nd story wall, so this is where we will certainly begin. In roof, shingles begin at the bottom overhang of the roof covering as well as are laid up the roofing to the peak.

Tidy the debris from the area of roof you will certainly be servicing.

Get rid of the roof covering cap, starting at the wall surface, back to the size of the first tile at the top of the roof.

Remove the tiles from the wall surface. Start at the optimal, прочетете статия and work your way to the eve Remove just what is required. In our case, we eliminated no greater than one full tile (mainly partial roof shingles) all the way down.

Once the roof shingles and also nails are eliminated, fill the nail openings with roofing system sealer.

At this point, we can see that the 5x5 flashing, that goes from the roofing to the wall surface, had been installed inaccurately. At this point we decided the finest technique of fixing was going to be to fill in the old 5x5 gap with roof sealer and begin over with a brand-new design.

Load the space, from all-time low of the house siding to the roof covering deck, with roof sealer. You do not have to be specifically tidy below as it will certainly be covered with brand-new 5x5 blinking and also 1x4 stress treated trim.

Install new 5x5 flashing per manufacturers referrals. Make certain it is secured well.

Cut and also install your new roof shingles. Make sure the side that lays on the 5x5 steel has an extremely thick grain of sealant under it.

When your shingles are mounted, install your leading cap and you are performed with the tiles.

Cut and also mount the 1x4, approximately 2 inches off the roof covering deck, on the wall surface. Prior to mounting the 1x4 see to it you put a really thick grain of silicone or various other sealant behind the 1x4.

Repaint the 1x4 and also blinking.

After the paint has actually dried out, secure the top of the 1x4 to the exterior siding. Below you will certainly have some good sized spaces, so make sure you fill them well.

Clean up your mess as well as we can move on to the next action.

Earlier we spoke concerning reducing the quantity of water that flows onto this roof covering. There was around 400 square feet of roofing system water being dumped onto the roof covering listed below. In order to quit this we required to reroute the second story water right into rain gutters as well as down spouts leading the water away from this area.

The initial story roof covering in question is back-pitched into a 2nd tale wall surface. During a hefty rain water comes off of the second tale roofing and is unloaded onto the initial story roofing system. The problem is where the first tale roofing system fulfills the second story wall, so this is where we will certainly begin. In roofing, shingles start at the lower overhang of the roofing system and are laid up the roof to the top. There was about 400 square feet of roof covering water being discarded onto the roof covering below.